IJSER Home >> Journal >> IJSER
International Journal of Scientific and Engineering Research
ISSN Online 2229-5518
ISSN Print: 2229-5518 9    
Website: http://www.ijser.org
scirp IJSER >> Volume 3,Issue 9,September 2012
Simulation Approach for Quantifying the Homogeneity of In-cylinder Mixture Formation for Port Injected Diesel Fuel for PCCI/HCCI
Full Text(PDF, )  PP.183‐2I0  
B S Deshmukh, M K G Babu, M N Kumar, L M Das, Y V Aghav
— Euro IV, equivalence ratio, evaporation rate, fuel injection duration, fuel injection pressure, Homogeneous charge compression ignition (HCCI), intake air temperature, intake air pressure, Premixed charge compression ignition (PCCI), Port injection
This paper analyzes the port injected diesel fuel mixture formation for advance combustion strtegies like homogeneous charge compression ignition or premixed charge compression ignition system. The analysis combines the experimentl as well as simulation approach.
[1] Ryan III, T. W. and Challahan, T. J., ‚Homogenous charge compression ignition of diesel fuel‛, SAE Technical Paper, No. 961160 (1996).

[2] Suzuki H., Koike, N and Odaka, M, ‚Combustion control method of homogenous charge diesel engines‛, SAE Technical Paper, No.980509 (1998)

[3] Browne, K., R., Partridge, I., M., Greeves, G. (1986) ‚Fuel Property Effects on Fuel/Air Mixing in an Experimental Diesel Engine‛, SAE Paper 860223.

[4] Kaneko N., and, H., and Miyamoto, N., ‚Expansion of the operating range with in-cylinder water injection in a premixed charge compression igntion engine‛, SAE Technical Paper No. 2002-01-1743 (2002)

[5] Xiaolu Li, Jianguo Xing, Tao Hong, ‚Simulation and comparison of diesel mixture formation at different fuel injection advance angles‛, International journal of mathematics and computer in simulation, Issue 3, Volume 1, 2007.

[6] Jeong-Kuk Yeo, Byung-Mu Kang, Sung-Sik Chung, JongYul Ha, Hajime Fujimoto, ‚A Study on the Mixture Formation Process of Evaporating Diesel Spray by Offset Incidence Laser Beam‛, KSME International Journal, Vol. 16 No. 12, pp. 1702~ 1709, 2002.

[7] Takeda, Y., Keiichi, Na., Keiichi, Ni. (1996) ‚Emission Characteristics of Premixed Lean Diesel Combustion with Extremely Early Staged Fuel Injection‛, SAE Paper 961163.

[8] Aoyama, T., Hattori, Y., Mizuta, J., Sato, Y. (1996) ‚An Experimental Study on Premixed-Charge Compression Ignition Gasoline Engine‛, SAE Paper 960081.

[9] Suzuki, H., Koike, N., Ishii, H., Odaka, M. (1997) ‚Exhaust Purification of Diesel Engines by Homogeneous Charge with Compression Ignition Part 1: Experimental Investigation of Combustion and Exhaust Emission Behavior Under Pre-Mixed Homogeneous Charge Compression Ignition Method‛, SAE Paper 970313.

[10] Yokota, H., Kudo, Y., Nakajima, H., Kakegawa, T., Suzuki, T. (1997) ‚A New Concept for Low Emission Diesel Combustion‛, SAE Paper 970891.

[11] Iwabuchi, Y., Kawai, K., Shoji, T., Takeda, Y. (1999) ‚Trial of New Concept Diesel Combustion System – Premixed Compression-Ignited Combustion‛, SAE Paper 1999-01- 0185.

[12] Epping, K., Aceves, S., Bechtold, R., and Dec, J., ‚The potential of HCCI combustion for high efficiency and low emissions,‛ SAE technical paper No. 2002-01-1923 (2002).

[13] Alperstein, M. Siwim, W. B., Schweitzer, P.H., ‚Fumigation kills smoke improves diesel combustion,‛ SAE Transactions, Vol 66, PP. 574-595 (1958).

[14] Ryan III, T. W. and Challahan, T. J., ‚Homogenous charge compression ignition of diesel fuel,‛ SAE Technical Paper, No. 961160 (1996).

[15] Gray A. and Ryan III, T. W., ‚Homogeneous charge compression ignition (HCCI) of diesel fuel,‛ SAE Technical Paper, No. 971676(1997).

[16] Nakagome K., Shimazaki, N, Niimura, K., and Kobayashi, S., ‚Combustion and emission characteristics of premixed lean diesel combustion engine,‛ SAE Technical Paper, No. 970898 (1997).

[17] Mase, Y., Kawashina, J. I., Sato, T and Euguchi, M., ‚Nissan’s new multivalve DI diesel engine series‛, SAE Technical Paper, No. 981039 (1998)

Untitled Page